Fujitsu Connectivity Peripherals Point 1600 Installation Manual page 22

Mouse Port
(on cradle module)
Connectors on the port replicator are described in Table 2-2.
Port
Serial Port A
Serial Port B
Parallel Port
Floppy Disk
Drive Port
Mouse Port
(on portable
port expander)
Video Port
DC Input
Keyboard Port
Mouse Port
(on cradle
module)
* Because of its modular design, the port replicator is equipped with two mouse ports. Only
one mouse device should be connected at a time.
2-6 Assembling and Installing Connectivity Peripherals
DC Power
Input Port Mouse Port (on portable port expander)
Serial Port B
Serial Port A
Keyboard Port Floppy Disk
Drive Port
Figure 2-5. Bottom View, Port Replicator
Table 2-2. Port Replicator Connectors
This connector can be used to connect an external device with a
serial interface such as a modem. This is a fully-functional RS232-C
serial port.
This connector can be used to connect an external device with a
serial interface. Note the following:
1) This port provides only the Rx and Tx (receive and transmit)
signals of the RS232-C interface. 2) When this port is enabled, the
IrDA port on the pen tablet is disabled.
This connector can be used to connect a device with a parallel
interface such as a parallel printer.
This connector can be used to connect the Fujitsu FMWFD2 floppy
disk drive.
*
This connector can be used to connect a PS/2-style mouse. When
used with the Point 1600 pen tablet, this connector can be connected
to either a PS/2-style keyboard or mouse.
This connector allows you to connect an external SVGA monitor.
Point 1600 pen tablet users: Note that an external monitor and the
pen tablet display screen cannot be viewed simultaneously.
This connector can be used to connect the AC adapter or auto
adapter.
This connector can be used to attach a PS/2-style keyboard.
* This connector can be used to connect a PS/2-style mouse.
Parallel Port
Video Port
Description