Dell Latitude C400 Service Manual page 32

Display Assembly and Display Latch : Dell Latitude C400 Service Manual
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any
installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted
metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the
procedure.
To replace the display latch, you must replace the whole bezel.
1. Remove the battery.
2. Remove the hard
3. Open the display 180 degrees, and remove the six rubber screw covers and the six M2 x 4-mm screws that
secure the bezel.
Bezel Removal
1 bezel
2 display latch
3 M2 x 4-mm screw (6)
4 display assembly
4. Use a small flat-blade screwdriver to carefully pry around the perimeter of the bezel until the bezel
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA.../Latitude/C400/C400_SERVICE_MANUAL/display.htm (4 of 5)6/21/2004 1:20:13 AM
drive.
Computer" before performing the following