D-Link DI-824VUP+ 2.4GHz Wireless VPN Router and Print Server Quick Installation Manual page 2

Connecting The DI-824VUP+ 2.4GHz Wire-
less VPN Router To Your Network
A. First, connect the power adapter to the receptor at the back panel of the
DI-824VUP+ and then plug the other end of the power adapter to a wall outlet or
power strip. The Power LED lights up indicating proper operation. (Fig. A)
B. 1. Power off your Cable or DSL modem; the devices that do not have a on/off
switch and will require you to unplug the power adapter. Now, the DI-824VUP+
should be powered on and the Cable / DSL modem should be turned off.
Cable / DSL modem
2.Connect an Ethernet cable to the Ethernet jack located on the Cable / DSL
modem. After the Ethernet cable is securely connected, power on the Cable / DSL
modem by turning on the unit or plugging in the power adapter.
Cable / DSL modem
3. Insert the other end of the Ethernet cable to the WAN PORT on the back panel
of the DI-824VUP+. The WAN LED light will illuminate to indicate proper
connection. If the WAN LED is not illuminated, please go back to step B1 and
repeat the steps. (Fig.C)
(Power Off) – DI-824VUP+
(Power On) – DI-824VUP+
2
(Fig. A)
(Power On) (Fig.B)
(Fig. B)
(Power On)