1. Connect the reserve battery cable to the system board connector.
2. Position the reserve battery above the speaker connector on the system board.
3. Update the BIOS using a flash BIOS update program floppy disk or CD. For instructions on how to flash the BIOS, see
System Speaker Assembly
Removing the Speaker Assemblies
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
Read
"Preparing to Work Inside the
The speakers are located on the front left and right sides of the bottom case. Each speaker assembly is marked with a left or right label. Take note of the
speaker and antenna wire routing so that you can replace them properly under their routing clips.
Computer" before performing the following procedure.