Telephone Operation - AEG Voxtel C115 User Manual

9
Press the OK button
>The third digit of the code will be blinking.
Press the up or down
Press the OK button
he stop button
8.8 TAM HD on/off setting
Two different compression rates (on and off) are provided for you to select the recording quality / total
recording time of incoming messages. With the compression rate set to on the recording quality will
be higher, but it will only save up to about 20 minutes of messages. With the compression rate set to
off the recording quality will be lower, but it will save up to about 40 minutes of messages.
Press the menu button
>The display shows "OPTIONS MENU".
Press the up or down
Press the OK button
>The "ON" (or "OFF") will be blinking.
Press the up or down
Press the OK button
9

TELEPHONE OPERATION

9.1 Ringer volume
The ringer high / low switch located at the back of the base unit, allows you to adjust the volume of
the ringer.
High volume
Low volume
9.2 To make a call
Lift the handset or press the speakerphone button
>Check for dial tone.
Dial the telephone number.
>The display shows the duration of the call in minutes and seconds.
OR Using pre-dialling:
Dial the telephone number.
>If you make a mistake you can correct it by using the delete button
adding the right ones.
Lift the handset or press the speakerphone button
9.3 To answer a call
When the phone rings, lift the handset or press the speakerphone button
>The display shows the duration of the call in minutes and seconds.
9.4 To adjust the speakerphone volume
During a call, adjust the volume of the speakerphone to your comfortable volume level using the
volume buttons
>The display shows the volume level from 1 to 6 in the lower left corner of the LCD screen.
9.5 To end a call
>Replace the handset on the base unit cradle or press the speakerphone button
to confirm.
button to set the third digit of the remote access code.
to confirm the new remote access code setting.
to return to standby mode.
.
button until de display shows "TAM HD: ON" (or "TAM HD: OFF").
to confirm.
button to select "ON" or "OFF".
to confirm the TAM HD setting.
located on the top of the base unit.
on the base unit.
to delete digits and then
on the base unit to dial out the number.
on the base unit.
on the base unit.