System Hardware; General Comments - NEC Express5800 MC2400 Release Note

System release notes

Hide thumbs Also See for Express5800 MC2400:

Introduction

These System Release Notes cover the following topics:

Advisories

Documentation Errata

General Comments

The following general comments apply to this server.

Versions of the Network Operating Systems tested and recommended are:

Advisories

This section contains advisories on the System Hardware,

Novell NetWare, and SCO.

System Hardware

The following advisory applies to the Expansion Board Slots:

When installing or removing an expansion board, it is recommended that

the board be held by its top edge or upper corners, aligned with its mating

connector on the system board (when installing), and pressed firmly into

or pulled firmly from its expansion slot. You might need to gently rock

the board side-to-side to align and seat or unseat it fully in or out of its

connector.

The following advisory applies to installing or removing a hard disk drive:

When installing or removing a hard disk drive, it is recommended that its

carrier handle be left in a straight outward position after it is opened, until

either the carrier is fully seated in its connector or removed from the drive

bay. To move a hard disk drive in or out of a bay, the outside edges of the

carrier's front panel should be used.

Windows NT® 4.0 Server with Service Pack 4

Novell® NetWare® 3.12

IntraNetWare 4.11 with Support Pack 5b

SCO OpenServer™ 5.04 with Maintenance Supplement 504C.

UNIXWare 7.1

Express5800 MC2400 System Release Notes 3

XPRESS

UILDER,

Table of Contents