Taking Out The Cassette In Tape Slacking - Sony HDW-1800 Installation Manual

3. Open the eject levers on both ends of the board in the
direction of the arrows.
4. Hold the eject levers and slowly pull the board out.
1 1
2
Pulling out
n
The SY-340 and DU-386 boards should be removed
together due to their structural feature.
Reattaching
When reattaching the board, install in the reverse order of
removal.
m
. After inserting the board, push in the two folded eject
levers simultaneously to firmly connect the plug-in
board to the connector on the motherboard.
. When reattaching the upper lid (rear) assembly, be sure
to insert the protrusions in the square holes on the
chassis, and then secure the lid.
HDW-1800/D1800
1 1
3 3
2
Insertion
1-17. Taking Out the Cassette in Tape
Slacking
When slacking the tape in this unit, follow the steps below
to take out the cassette tape.
n
Being careful not to damage the tape, take out the cassette
tape with care.
1. Turn off the power.
2. Fully loosen the fixing screw.
3. Slide the knobs on upper lid (front) assembly each in
the inside. (Move the knobs to the outside to fix the
upper lid (front) assembly.
4. Remove the upper lid (front) assembly.
Knob
Fixing screw
Upper lid (front) assembly
Knob
Removal
Installation
1-23 (E)