Turn On The Power Switch - Canon Speedlite 58OEX Instruction Manual

Turn on the Power Switch
ttMt
Fjd
H' liPi
@E~~Z6OJ~-~~
1
Set the power switch to
<ON>.
, l>
The flash will start recycling.
Check that the flash is ready.
~
The pilot lamp will first turn green (ready for
quick flash), then red (fully recycled or flash
ready).
~
To fire a test flash, press the pilot lamp.
About Quick Flash
Quick flash enables a flash to be fired before flash-ready, when the pilot lamp
is still green.
Although the Guide No. will be 1/6 to 1/2 that of the full output, quick flash is
effective for near subjects and when you want a shorter recycle time.
Set the drive mode to Single. Quick flash cannot be used in the continuous
shooting, FEB, manual flash, and stroboscopic flash modes.
About Auto Power Off
To save battery power, the power will turn off automatically after 90 sec. of
idle use. To turn on the Speedlite again, press the shutter button halfway.
Or press the Speedlite's test firing button.
[l] . ; ; .
A test firing cannot be fired while the camera's operation timer
04
or
06
is active.
1$
The Speedlite's settings will be retained in memory even after the power is turned off.
To retain the Speedlite's settings when you replace the batteries, replace the batteries
within 1 minute after turning off the power.
10