Select To Faders Panel - Sony OXFORD Operation Manual

6-2-2 Select to Faders Panel

The following illustration shows the left Select to Faders Panel, which is
located immediately to the left of the centre section of the control surface.
The right hand Select to Faders Panel, located immediately to the right of
the centre section, has a panel layout which is a mirror image of the one
described here.
This Panel assigns fader banks to control desired signal paths.
The various push-buttons allow assignment of signal paths to channel
faders as per button designation and the previous Fader description.
Channel faders may be switched to control:
Gain of Mic, M/T and Line
• INPUT GAIN
• M/T SEND Level sent to M/T bus
• GROUP TRIM Gain of M/T Bus Output to M/T Channel
• M/T MONITOR Level Sent to Independent M/T Monitor Bus
• CHANNEL Channel Level Sent to Main Output Busses
• SUPER SGs Levels Sent to Super Send Group Outputs
• SENDS Levels Sent to Effects & Foldback Outputs
Levels Sent to the Sub Bus in Multi-Format Mode
• SUB LEVEL
Chapter 6 Technical Descriptions
6-9