• Obey the installation instruction supplied with the appliance. Water connection • Make sure that the appliance is installed be- • Make sure not to cause damage to the water low and adjacent to safe structures. hoses. Electrical connection www.zanussi.com...
Page 3
Model : • Do not sit or stand on the open door. PNC : • Dishwasher detergents are dangerous. Obey Serial Number : the safety instructions on the detergent packaging. www.zanussi.com...
4. Press immediately the programme button. cator comes on. • The programme indicator (A) comes on • The acoustic signals are on. with a fixed light. 4. Deactivate the appliance to confirm the set- • The programme indicator (B) starts to ting. flash. www.zanussi.com...
< 0.7 < 5 1) Factory position. 2) Do not use salt at this level. Manual adjustment You must adjust the water softener man- ually and electronically. Turn the water hard- ness dial to the posi- tion 1 or 2. www.zanussi.com...
Page 7
Filling the rinse aid dispenser ting. Filling the salt container Caution! Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent it, after you fill the salt container, start a programme. www.zanussi.com...
6. Set and start the correct programme for the type of load and the degree of soil. Using the detergent If the programme has a prewash phase, put a small quantity of detergent on the in- ner part of the appli- ance door. www.zanussi.com...
The water softener neu- tralises these minerals. Hard water contains a high quantity of minerals The dishwasher salt keeps the water softener that can cause damage to the appliance and clean and in good conditions. It is important to www.zanussi.com...
Care and cleaning Cleaning the filters Warning! Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Dirty filters and clogged spray arms de- crease the washing results. Make a check regularly and, if necessary, clean them. www.zanussi.com...
Alarm code Problem • The indicator of the set programme flashes contin- The appliance does not fill with water. uously. • The end indicator flashes 1 time intermittently. www.zanussi.com...
Page 12
• The quality of the rinse aid can be the cause. much. Adjust the rinse aid selector to a lower Refer to ‘HINTS AND TIPS’ for other pos- position. sible causes. • The quantity of detergent is too much. www.zanussi.com...
By ensuring this product where you purchased the product. is disposed of correctly, you will help prevent potential negative consequences for the • Discard correctly the packaging material. Re- cycle the materials with the symbol www.zanussi.com...