Hard Disk Drive Heater; The Media Bay; To Change Swappable Media Bay Device; To Insert A Disk - Hitachi GD8000 User Manual

GD8000 User Guide

Hard Disk Drive Heater

The hard disk drive heater warms the HDD before spinning
up in temperatures below 5°C, the minimum safe operating
temperature for the HDD. The heater is integrated and
operates as needed when the computer is on. If the
temperature is below 5°C when booting or resuming you will
see the message "Warming internal hard drive. Please wait...".
The unit will continue booting when it detects the HDD is warm
enough to operate safely.
NOTE
If you are using the computer in a cold temperature
environment and the battery level is too low for the heater to
operate, you will see the error message "Battery too low to
warm the hard drive. Shutting down..." and the computer will
shut down. Apply external power and reboot.

The Media Bay

Depending on your configuration, your computer may have
an optional DVD multi-drive (DVD-RAM/DVD-ROM/DVD-RW/
CD-R/CD-ROM/CD-RW) or media bay battery. The multi-drive
allows you to read data from DVDs and CDs, including audio
or video CDs, and enables you to burn your data onto a CD or
DVD recordable disc. Please refer to the recording software
online help for more information.
If you have the media bay battery, it extends your unplugged
runtime.
Your notebook identifies the drive with the letter following the
hard drive and/or recovery partition letter. If your hard drive is
C, then the media bay will be E if you have a recovery partition.
It will be D if you do not have a recovery partition.
Media Bay
Screw and Lock
General Dynamics Itronix | 72-0137-003
Media Bay
Release
Getting Familiar With Your Computer

To Change Swappable Media Bay Device

1.
Make sure the computer is not accessing the media bay drive.
2.
Open the media bay door cover.
3.
Safely Remove Hardware
Double-click the
Windows tray taskbar.
4.
Media Bay
Select the device, then select
5.
safe to remove hardware
Wait for the "
OK
.
6.
Turn your computer over so you are looking at the bottom.
7.
If installed, remove the screw in the media bay lock.
8.
Slide the media bay lock toward the back of the computer and
hold.
9.
While holding the media lock in the unlocked position, slide
the media bay release toward the outside of the computer. The
media bay should come part way out of the computer.
10.
Grasp the media bay device by the edges and pull straight out
until it is clear from the slot.
11.
Re-insert the next media bay device by firmly pushing it back
into the slot until it clicks into place.
CAUTION
Do not remove or change any hardware while
your computer is hibernating or in a Sleep/Standby state.

To Insert a Disk

1.
Open the media bay
door cover.
2.
Insert the disk into the
media bay slot.

To Remove a DVD or CD

1.
Make sure the computer is not accessing the DVD drive.
2.
Press the eject button. The disk will automatically eject.
3.
Pick up the disk by the edges and remove it from the slot.
Multi Drive Eject Button
CAUTION
When the computer is reading from a DVD or
CD, the Optical Disk Drive LED will flash on. Do not attempt to
remove a disk while this light is active.
icon on the
Stop
.
" message, then click