Table of Contents
Advertisement
MIC412TI and MIC412TF Camera | Installation and Operation Manual
MIC Model
This provides a list of all the available MIC Models. This should be set to the type
of camera being controlled as Camset is then set up accordingly to provide more
or less options dependant upon the combination of this setting with the Camset
Protocol above.
Comm Port
This provides a list of the available Comm Ports detected by the software on the
PC. If a comm port is in use when it is selected the user will be prompted with an
error, and should either select another port or close the application currently using
it.
If the MIC-USB485CTR, USB to RS485 convertor is being used, when plugged in
this will show on the Comm Port drop down menu as USB, simply select to use.
The final option is close which will close any open communications port meaning
that other applications can then use the port for other purposes.
Camset Baud Rate
This displays the current Baud Rate at which outgoing messages are sent, and the
other options available for the given protocol above. Changing this without first
changing the MIC baud rate will cause a loss of communications.
RTS
This defines the state of the RTS line on the serial port which can be used power
in line RS232 to 485 adapters.
Comms Mode
There are 3 available options for comms modes:
Full
Duplex: Full 2 way 4 wire communications connection. Messages are
transmitted and received on separate comms pairs.
Half
Duplex: 2 way, 2 wire communications connection. Messages are transmitted
and received on the same pair of wires. The 485 drivers deal with the switching of
the line directions automatically.
Simplex: 1 way 2 wire communications connection. Messages are only transmitted
Bosch Security Systems
to the camera. This will work for most manual controls, but anything that requires a
response, such as Pot Test, Exact Positioning, and Programming etc will fail.
Reset Camset
This re-initializes all of the controls for the software to the state it would be on boot.
Manual Control
Pan, Tilt and Zoom Controls
The Up, Down,
Left
and
Right
selected direction at the speed indicated by the
Issue 8
AAA
buttons send commands to the MIC to move in the
Speed
Slider.
EN | 25
Advertisement
Table of Contents
