Table of Contents
Advertisement
MIC412TI and MIC412TF Camera | Installation and Operation Manual
Set Mask Type
If Crosshair and Mask Style are both turned On this function can be used to step
through each of the available mask types one at a time. This will not update all the
masks to the same type, only the ones that are created subsequent to the change.
Load Factory Defaults
Resets the privacy card to the factory defaults.
MIC Configuration
These options define the MIC's orientation, which defines how the masks track. for
Inverted MICs, the head would normally be rolled around through 180 degrees,
with Pan Reverse On to regain sensible control. However, with inverted IR MICs,
the head cannot be rotated around due to the IR Lamp arms, and therefore the
video must be inverted, and both controls reversed.
Basic Calibration
This sends a set of default commands to the MIC to initialize the privacy for an
upright MIC. This will not be perfect as each board needs fine individual calibration
but provides a good starting point.
Zoom Alignment
The zoom alignment buttons provide accurate calibration of the mask tracking.
This would normally be carried out by using a vertical line of mask on along a
known straight edge. If this line then moves as the MIC pans and tilts, it can be
corrected using the appropriate arrow. The labels indicate the current value in both
the Vertical and Horizontal planes, which will be incremented or decremented
dependant upon the direction pressed.
Direct Command
All privacy commands consist of 2 Hex bytes, a command byte and a data byte.
These perform all of the privacy functions available. To enter commands, enter the
2 bytes in Hex, into the boxes provided and press
random commands here may result in very odd results so please do not use
unless under specific instruction.
Save Current Settings
Bosch Security Systems
Send
Command. Entering
Once any calibration changes are made, this button should be pressed to save the
new values permanently.
Privacy Calibration
CAUTION: The Privacy Calibration settings should be
configured at manufacture and should therefore not need to
be changed on site.
Any changes to these settings may be difficult to correct, so
please do not attempt to change anything unless under
instruction from Bosch.
The
Privacy Calibration
section deals with the calibration settings of the privacy
masking. I.e. how the masks track as the MIC is moved in Pan, Tilt or Zoom.
MIC Configuration
These options define the MIC's orientation, which defines how the masks track. for
Inverted MICs, the head would normally be rolled around through 180 degrees,
with
Pan Reverse On
to regain sensible control. However, with inverted IR MICs,
the head cannot be rotated around due to the IR Lamp arms, and therefore the
video must be inverted, and both controls reversed.
Basic Calibration
This sends a set of default commands to the MIC to initialize the privacy for an
upright MIC. This will not be perfect as each board needs fine individual calibration
but provides a good starting point.
Zoom Alignment
The zoom alignment buttons provide accurate calibration of the mask tracking.
This would normally be carried out by using a vertical line of mask on along a
known straight edge. If this line then moves as the MIC pans and tilts, it can be
corrected using the appropriate arrow. The labels indicate the current value in both
the Vertical and Horizontal planes, which will be incremented or decremented
dependant upon the direction pressed.
Direct Command
Issue 8
AAA
EN | 34
Advertisement
Table of Contents
