Bosch PLN-6TMW Installation And User Instructions Manual page 25

Plena Weekly Timer | Installation and User Instructions | Programming a schedule
table 7.2: Output contact trigger settings
Trigger Status of event
settings
An event is switched on, and stays
on until switched off.
An event is switched off.
An event is switched on, and then
immediately switched off (pulsed).
No event selected.
The
Plena Weekly Timer Configuration
software. If you do not want to select
an event using the display, turn the
rotary selector until no symbol is
displayed.
Note
The output contacts are Normally Open (NO)
contacts.
Note
When an event is started, the software will set
the output contacts according to the settings of
that current event (and will ignore the settings of
any previous events). For example, if an output
contact that was already open is set to open,
nothing will happen.
Bosch Security Systems | 2006-05 | 9922 141 50741 en
symbol is only used for the
Status of switch
Closed
Open
Closed, and then
immediately open
Open
en | 25
Example
A light is switched on
After a while, the same
light is switched off
A message is started
Nothing happens