Advertisement
Quick Links
Advertisement
Related Manuals for Electrolux EFA9620
Summary of Contents for Electrolux EFA9620
- Page 1 USER MANUAL EFA9620...
- Page 3 3 RECOMMENDATIONS AND SUGGE- STIONS CHARACTERISTICS MAINTENANCE...
- Page 4 Thank you for choosing a fi rst class product from Electrolux, which hopeful- ly will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality prod- ucts that make your life more comfort- able.
- Page 5 5...
-
Page 6: Recommendations And Suggestions
6 electrolux Recommendations and Suggestions RECOMMENDATIONS AND SUGGESTIONS Installation • Adjust the fl ame intensity to direct it onto the bottom of the pan only, mak- • The manufacturer will not be held li- ing sure that it does not engulf the able for any damages resulting from sides. -
Page 7: Characteristics
7 Characteristics CHARACTERISTICS Dimensions... - Page 8 8 electrolux Characteristics Components Ref. Q.ty Product Components Hood Body, complete with: Con- trols, Light, Blower, Filters Telescopic Chimney comprising: Upper Section 7.1a Lower Section Telescopic frame complete with extractor, consisting of: 7.1a 1 Upper frame 7.1b 1 Lower frame Reducer Flange ø...
- Page 9 9 Installation INSTALLATION Drilling the Ceiling/shelf • Use a plumb line to mark the centre of the hob on the ceiling/support shelf. • Place the drilling template 21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob.
- Page 10 10 electrolux Installation Fixing the frame • Loosen the two screws fastening the lower chimney and remove this from the lower frame. • Loosen the two screws fastening the upper chimney and remove this from the upper frame. If you wish to adjust the height of the frame, proceed as follows: •...
- Page 11 11 Installation Connection in Ducting Version When installing the ducting version, ø 150 ø 120 connect the hood to the chimney using either a fl exible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer.
-
Page 12: Use
12 electrolux Installation / Use Electrical Connection • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. • Remove the grease fi lters (see para- graph Maintenance) being sure that... - Page 13 13 Touch Basic functions Indicator lights control Dual Function When briefl y pressed it switches the lighting Touch control Lights off system on and off. unlit When pressed for 2 seconds it starts the Touch control lit Lights on lighting system in “courtesy light”...
-
Page 14: Maintenance
14 electrolux Maintenance MAINTENANCE Cleaning the Comfort Panels Cleaning of the Metal Cassette Filters • Pull the Comfort Panel to open it. • Disconnect the panel from the hood Alarm reset canopy by sliding the fi xing pin lever. • Stop the motor. - Page 15 15 Maintenance Replacing the Charcoal Filter Reset the alarm signal • Stop the motor. This fi lter cannot be washed or regene- • Press the touch control F for at least rated, and must be replaced when the F 4 seconds, until the touch control T1 touch control starts to fl...
- Page 16 16 electrolux...
- Page 18 436003562_03 - 070130...