Panasonic KX-TD7896 User Manual page 37

Problem
The date and time are not
displayed correctly when viewing
the Incoming Call Log.
While Caller ID is displayed using
the Incoming Call Log, the
display goes blank after pressing
. (KX-TA624/824 only)
Some dialed calls are not stored
in the Outgoing Call Log.
Even when in standby mode, you
cannot access the Phonebook or
other menus.
( is displayed in standby
mode.)
Noise is frequently heard.
Two short beeps are heard
during a conversation.
The charge indicator flashes red
rapidly.
You charged the battery for 7
hours, but the beep tones sound
and (needs to be charged)
flashes after a few telephone
calls.
While operating the unit, the AC
adaptor feels warm. While
charging the battery, the handset
feels warm.
Troubleshooting and Error Messages
→ Only for "PBX Type-Type 2
date and time on the base unit. The form of the date and
time can be set on the handset. (See "Setting the Date and
Time" on page 7.) (See page 35.)
→ Only for "PBX Type-Type 1
settings can only be changed on the PBX.
• Caller ID is displayed for about 20 seconds. If you press
during that time period, the display goes blank until
the time expires.
→ Press
→ Outgoing calls using some PBX features (e.g., Redial, One-
touch Dialing or Speed Dialing) cannot be stored in the
Outgoing Call Log.
• The BGM setting may be on.
→ KX-TA824: Set program [626] BGM Control for APT to
"Disable" in PBX System Programming.
→ KX-TA308/624: Press "1" to turn BGM off.
→ Set the handset and base unit away from other electrical
appliances.
→ Move closer to the base unit.
• The radio signal is weak.
→ Move closer to the base unit.
• The charger is not connected properly.
→ Make sure the battery is inserted properly.
→ Set the handset in the charger properly.
• The battery charge contacts may be dirty.
→ Clean the battery charge contacts without damaging them
and charge once more.
• It is time to change the battery.
→ Replace with a new one.
• These are normal conditions.
Description and Solution
(KX-TA308)
(KX-TA624/824)
then press to return to the standby display.
": Set the correct
": Time
37