Table of Contents
Advertisement
Display
EP end of life
replace EP Cart.
Tray # open
Finisher gate is open
Finisher transport open
Finisher Front door open
Finisher Top door open
Finisher
Compiler open
Finisher
Docking open
Left high
door open
Left middle
door open
Left low
door open
Duplex module
door open
Lifting Tray #
Paper out tray #
XXX
Face Down Tray
paper full
Finisher
all bins full
Finisher bin # full
Call Operator
Duplex fail
Call Operator
Finisher fail
Call Operator
Tray # Fail
Configuration changed
cycle power
20
Replace EP Cartridge.
Check for and close the specified tray. (# = tray number 1 through 5.)
Check for and close Finisher gate.
Check for and close Finisher transport.
Check for and close Finisher front door.
Check for and close Finisher top door.
Check for and close Finisher compiler.
Check for and close Finisher docking.
Check for and close left high door.
Check for and close left middle door.
Check for and close left low door.
Check for and close Trayless Duplex door.
The lifter in the specified tray is raising the paper stack so that the top
sheet is in the feed position. (# = tray number 1 through 5.)
# = tray number 1 through 5.
XXX = Media type (The following abbreviations are used, transpar.,
trans.-pp, preprint, letterhead).
Remove paper from the Face-down tray.
Remove paper from all the Finisher bins.
Remove paper from specified bin. (# = bin number 1 through 3.)
Power printer off then on. If not cleared, call your service representative.
This can result if you have removed the paper from the Compiler tray
before it has reached the bin. Power printer off, then on. If it has not
cleared, call your service representative.
Power printer off then on. If not cleared, call your service representative.
(# = tray number 1 through 5.)
Cycle printer power.
Description/Action
Quick Reference Guide
Advertisement
Table of Contents
