Measurement Configuration Commands - HP 34401A User Manual

Chapter 4 Remote Interface Reference

Measurement Configuration Commands

Measurement Configuration Commands
See also "Measurement Configuration," starting on page 51 in chapter 3.
function
FUNCtion "< >"
Select a measurement function. The function must be enclosed in quotes
in the command string (FUNC "VOLT:DC"). Specify one of the following
strings.
VOLTage:DC
VOLTage:DC:RATio
VOLTage:AC
CURRent:DC
CURRent:AC
2-wire ohms
RESistance ( )
FUNCtion?
Query the measurement function and return a quoted string.
< function>:RANGe {<range
Select the range for the selected function. For frequency and period
measurements, ranging applies to the signal's input voltage, not its
frequency (use FREQuency:VOLTage or PERiod:VOLTage).
the lowest range for the selected function.
range. [Stored in volatile memory]
< function>:RANGe? [MINimum|MAXimum]
Query the range for the selected function.
function>:RANGe:AUTO {OFF|ON}
<
Disable or enable autoranging for the selected function. For frequency and
period, use FREQuency:VOLTage or PERiod:VOLTage. Autorange thresholds:
Down range at <10% of range; Up range at >120% of range. [Stored in volatile
memory]
function>:RANGe:AUTO?
<
Query the autorange setting. Returns "0" (OFF
4-wire ohms
FRESistance (
FREQuency
PERiod
CONTinuity
DIODe
>|MINimum|MAXimum}
selects the highest
MAX
) or "1" (
)
selects
MIN
).
ON
121
4