Using the remote control
To use the remote control, follow these steps:
1.
Be sure that the remote control batteries are installed. Refer to
control batteries on page
2.
Be sure that the remote sensor is connected to the computer. Refer to Chapter 3,
on page
3.
Turn on the computer.
4.
Point the remote control at the remote sensor to use it to control the TV tuner.
NOTE:
blocks the path between your remote control and the remote sensor.
The remote control must be pointed at the remote sensor when any button is pushed for the TV tuner
to receive the signal.
32, later in this chapter.
6, for details.
The remote sensor should be located in a convenient place. Be sure that nothing
Inserting or replacing the remote
TV tuner setup
Using the remote control
31