HP 1032 Manual page 9

Step 11 Run mp_register on the Management Server
Back to Top
Step Q12 Power up the Compute Nodes
Use the clbootnodes program to power up all Compute Nodes that have a connected
Management Processor that you specified in the previous step. The clbootnodes program
will provide the following information to the Compute Nodes:
Language to use,
Host name,
Time and time zone settings,
Network configuration,
Root password.
For more information, see the Comprehensive Instructions for this step.
References:
Step 12 Power up the Compute Nodes
Back to Top
Step Q13 Run compute_config on the Management Server
The compute_config program will register the nodes with various programs.
For more information, see the Comprehensive Instructions for this step.
References:
Step 13 Run compute_config on the Management Server
Back to Top
Step Q14 Run finalize_config on the Management Server
This program completes the installation and configuration process, verifies the Cluster
Management Software, and validates the installation. If it reports diagnostic error messages,