HP R1500 - UPS XR User Manual page 8

Inserting the Batteries
Slide the batteries into the chassis (1), bottom to top, and tighten
the screws (2).
Attaching the Bezels
1. Place the supervisory bezel on the chassis (1) and tighten the
screws (2).
2. Plug the LCD power cable into the connector on the control
bezel (1), lift the bezel (2), and snap the bezel into place (3).
2
1
2
1
1
2
2
3
3. Snap the remaining bezels into place. Verify that the ventilation
holes are over the electronics modules.
Connecting the Communication Ports to
Other Devices
CAUTION: To avoid damage to the equipment, only use the
communications cables that came with the UPS kit, part number
201092-002 (12-ft serial interface cable). This UPS/computer
interface cable carries power and is specifically designed for UPS
communications.
The UPS has two serial ports for communication with the host
server, and two option slots. The two option slots are available for
future enhancements.
Connect the serial port to a communication port on the host server
using a UPS/computer interface cable.