Setting Up The Computer; Installing The Touch Display Driver - Sharp TOUCH DISPLAY DRIVER Operation Manual

To use the touch panel, the touch display driver must be installed and the touch panel must be connected to your computer.

Installing the touch display driver

The touch display driver is a program that enables you to use the touch panel to operate the computer that is connected to the
touch panel.
Caution
• To install, an administrator name (user name) and password are required.
• If an older version of the touch display driver is installed, remove (uninstall) the old version before installing the touch display
driver. (See page 10.)
• Do not touch the touch panel when connecting the USB cable.
If you touch the touch panel, it will lead to a malfunction. In this case, disconnect and then reconnect the USB cable.
1. Start your computer.
2. Exit all applications that are running.
3. Connect the USB cable for the touch panel to the computer.
To the USB terminal
4. Run the setup program.
(1) Double-click the "TouchDisplay" folder, and then double-click the "Mac" folder.
(2) Double-click "SharpTouchDisplay.mpkg".
5. Click "Continue".
Follow the on-screen instructions to install the driver.
• If a screen prompting you to enter the name and password appears, enter the name and password of the administrator
and click "Install Software" (or "OK").
• If the "When this software finishes installing, you must restart your computer. Are you sure you want to install the software
now?" screen appears, click "Continue Installation".
6. When the installation finished screen appears, click "Restart".
This completes the installation of the touch display driver.
Each time the computer is started, the touch display driver will start automatically to enable the touch panel to be used.
4
E

Setting up the Computer

of the computer
USB cable (Supplied)
LL-S201A
USB port
USB port