Table of Contents
Advertisement
engages in the clutch. Refit the angle gear on the hollow
drive shaft and tighten the two screws.
Adjusting the edger's cutting
depth
The cutting depth must be adjusted before starting work.
•
Loosen the locking knob (A) and rotate the guard by
moving the locking knob forwards or backwards. If the
locking knob is moved forwards (away from the
machine) the cutting depth is increased. If the locking
knob is moved backwards (towards the machine) the
cutting depth is reduced.
A
•
Set the desired cutting depth.
•
Lock the locking knob.
CAUTION! Use only HUSQVARNA replacement parts.
Use of other brands of replacement parts can cause
damage to your unit or injury to the operator or others.
Your warranty does not cover damage or liability caused
by the use of accessories and/or attachments not
specifically recommended by HUSQVARNA.
22 – English
MAINTENANCE
1153252-95 Rev.1 2010-02-02
Advertisement
Table of Contents
