Unbypass A Point? (Command + 0 + 0) - Bosch Security System User Manual

UNBYPASS A POINT? (COMMAND + 0 + 0)

Description
Unbypassing a point is a way to return a bypassed point
to the security system so that it can once again respond
to trouble and alarm conditions.
Using Unbypass a Point:
1. Ensure your
command center
shows idle disarmed
text.
2. Press the COMMAND key.
The display shows
*System Command*.
3. Press the 0 + 0 keys.
4998122475C
+
UNBYPASS A POINT? (COMMAND + 0 + 0)
Note:
If you prefer, you may use the Command Menu
in place of steps 2 and 3 to initiate this function.
Press the Menu> key to enter the Command
Menu, then press Next> repeatedly until you
reach the UNBYPAS A POINT ?> prompt.
Press the UNBYPAS A POINT ?> soft key.
4. The display shows:
If you know the point
number you wish to
unbypass, enter the
number and
press the Enter> soft
key or the ENTER
button.
Security System User's Guide
Part II: System Commands