Optional Operations; Quick Arming; Force Arming - Bosch DS7400XiV4-EXP User Manual

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations
6.2

Optional Operations

6.2.1

Quick Arming

Quick arming allows you to enter some arming commands without first entering a PIN. If quick arming is not
used, you must enter a PIN at the beginning of all arming command sequences.
Quick arming is not available from a Master keypad or from RF (wireless) keypads.
The following shortcuts are allowed when the system is programmed for quick arming:
Table 9: Quick Arming
Type of Arming
Normal Arming
Perimeter Instant Arming – no entry delay
Perimeter Arming – entry/exit delay in effect
Maximum Security Arming
6.2.2

Force Arming

When one or more zones are faulted (for example, if a window or door is open), the system can be force armed (if
programmed) by bypassing the faulted zones. When a text keypad displays "Not Ready" and the zone LED(s) on
an LED keypad for the faulted zone(s) are lit, force arming is required to arm the system. Although an RF3341
keypad does not indicate a faulted state on the system, you can force arm the system from an RF3341 keypad.
You can also force arm an area using a master keypad in Single Partition Mode.
Force Arming during an AC power failure: Regular arming of the control panel is not permitted during an
AC power failure. The requirement to force arm serves as a warning that the control panel is operating under
backup battery.
Bypassing or force arming removes some of your building's protection because it excludes the faulted
zones from arming. Therefore, an intrusion might not be detected or the detection might be delayed.
Always attempt to correct any zone problems (close doors and windows, etc.) before using these
features. If you cannot correct the problem, contact your installing company.
Table 10: Force Arming
Equipment
Text Keypad LED
Keypad
RF3341 Keypad
RF3332/RF3332E,
RF3334/RF3334E
* Text Keypad only
Bosch Security Systems | 6/05 | 4998154961B
Command Sequence
Enter any Arming
Command Sequence.
Enter [Bypass] during the
five-second beep.
Any Arming Command
Sequence [9]
Quick Arming Command Sequence
[#][On]
[#][No Entry][Perimeter Only]
[#][Perimeter Only]
[#][No Entry][On]
What Happens
• The red Armed LED flashes during the
exit-delay period.
• All zones normally armed by the
Arming Command Sequence are
armed except for the faulted zones.
• The LED flashes indicating a signal
was sent to your security system.
• All zones normally armed by the
Arming Command Sequence are
armed except for the faulted zones.
Not applicable
EN | 13
What To Do
If leaving, exit during the exit-
delay period.
If leaving, exit during the exit-
delay period.