Perimeter Instant Arming - Bosch DS7400XiV4-EXP User Manual

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations
6.1.2

Perimeter Instant Arming

Use perimeter instant arming to arm only the exterior (perimeter) zones when you remain in the building. An exit
delay is in effect, but no entry delay is in effect so an alarm does occur upon entry.
The green Status LED must be lit and, if using a text keypad, "Ready to Arm" must be displayed. If the green
LED is not on or the keypad displays "Not Ready," you must use other methods to arm the system (refer to Section
6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).
Table 4: Perimeter Instant Arming
Equipment
Text Keypad LED
Keypad
RF3341 Keypad
RF3332/RF3332E,
RF3334/RF3334E
* Text Keypad only
** LED Keypad only
Bosch Security Systems | 6/05 | 4998154961B
Command Sequence What Happens
[PIN][No Entry] •
[Perimeter Only]
•
•
•
•
•
•
•
[PIN][#][2] •
•
The red Armed LED flashes.
"Perimeter Inst." is displayed. *
"Exit Now" is displayed during exit-delay. *
The green Status LED lights steady.
A single beep sounds.
The red Armed LED lights steady when
the exit-delay period ends.
The yellow Perimeter LED lights steady. **
Only exterior protection zones are armed.
The LED flashes indicating a signal was
sent to your security system.
Only exterior protection zones are armed.
Not applicable
EN | 8
What To Do
• Move freely around the
interior.
• Opening any exterior
door or window triggers
an alarm.
• Move freely around the
interior.
• Opening any exterior
door or window triggers
an alarm.