Others; Auto Off-No Sig; Digital Tuner Power Save; Audio Input - Fujitsu Aviamo P37FT05AEB User Manual

OTHER SETTINGS (FEATURES MENU) (Continued)

Others

Auto Off-NO SIG.

(1) You can make to the standby state automatically when the
no signal state continued during set up time.
"Auto Off-NO SIG." selection screen
a b
Press or to select the "Time".
c d
Press or to select the amount of time before the
standby state starts.
Off 1 min. 15 min.
Z
Press to store.
* The numerical value is the approximate amount of time
before the standby state starts.
(2) You can assign the black or white color for the background
color at the no signal state.
a b
Press or to select the "Background".
c d
Press or to select the displayed background displayed.
Black White
Z
Press to store.
* The background color changes to assigned color state
after approximate 20 seconds at the no signal state.

Digital Tuner Power Save

Saves Digital Tuner power consumption when watching analog
TV, video input, and RGB input other than digital terrestrial
TV (DTV).
Normally, when digital terrestrial TV (DTV) is watched very
little and analog TV and cable TV and DVD player are
watched by video input very much, setting to ON is
recommended.
c d
Each time you press or
Off On
[Off]: Power consumption not saved.
[On]: Power consumption saved.
* When set to On, it may take some time to switch to
digital terrestrial TV.

Audio Input

"Audio Input" settings screen
E-36
45 min. 60 min.
, the setting is switched.
You can use this option to select the available terminals to
receive the audio from input equipment.
a b
(1) Press or to select video input terminal.
(2) Select a related audio input terminal.
c
Each time you press or
appears in the following sequence:
No Audio Audio1
[No Audio]: No audio in the corresponding mode.
[Audio 1-2]: SCART
[Audio 3-4]: Selects Audio 3 through 4 for receiving
audio in the corresponding mode.
[Audio 5-6]: HDMI
* There is also "Audio Input" that cannot be selected.
* Repeat steps (1) and (2) for each piece of input
equipment.
Z
(3) Press to store.
* AUDIO menu will not be displayed when "No Audio" is
selected.
Screen Orbiter (RGB)
"Screen Orbiter" setting screen
You can use this option to move the screen position to
minimize phosphor-induced "burn-in".
Follow the steps below.
Mode/Time
(1) Select "Screen Orbiter" and press
The "Screen Orbiter" setting screen will appear.
a b
(2) Press or to select "Mode/Time".
(3) Select a desired pattern.
c
Each time you press or
appears in the following sequence:
Off Time Mode
[Off]: Disables Screen Orbiter.
[Time]: Moves the pattern approximately every one hour.
[Mode]: Moves the pattern when the power is turned ON
or when you switch between modes.
Moving Area
a b
(4) Press or to select "Moving Area".
c d
(5) Press or to select the range for moving the pattern.
c
Each time you press or
appears in the following sequence:
Min. Std. Max.
[Min.]: Pattern moves in small range. (About 5 pixels)
[Std.]: Pattern moves in moderate range. (About 10 pixels)
[Max.]: Pattern moves in wide range. (About 15 pixels)
Z
(6) Press to store.
* When the Screen Orbiter function is operated, some
screen contents at the top, bottom, right or left of the
screen may move offscreen.
d
, one of the available choices
Audio2 • • • • •
Z
.
d
, one of the available choices
d
, one of the available choices