Fujitsu ETERNUS DX80 S2 Manual page 12

Power Cords
Connect the power cords to the inlets of the power supply unit.
Use release ties to hold the power cords in place.
Cable
-Installation- "4.5 Power Cord Connection"
Basic Setup
S T E P
Use ETERNUS Web GUI to perform a basic setup of the ETERNUS DX Disk storage system.
ETERNUS DX Disk Storage System and PC Terminal Connection
Connect a PC terminal to the ETERNUS DX Disk storage system.
Connect the PC terminal to the MNT port of Controller 0 (CM#0) on the controller enclosure directly with the LAN
cable (for operation management).
LAN port
PC terminal
●
IMPORTANT
●
-Installation- "5.1.1 ETERNUS DX Disk Storage System and PC Terminal Connection"
Powering On
Turn on the PC terminal and the ETERNUS DX Disk storage system.
When turning on the ETERNUS DX Disk
IMPORTANT
storage system for the first time, volume
formatting operation, which is set as factory
default, may be performed. However, the
ETERNUS DX Disk storage system setting
operation can be continued.
-Installation- "5.1.2 Powering On"
Rear view
LAN cable
MNT port of Controller 0 (CM#0)
When the LAN cable for the MNT port of Controller 0 (CM#0) is connected to a network device, connect the
cable to a PC terminal.
Remove the LAN cable that is connected to the MNT port of Controller 1 (CM#1).
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
Controller enclosure
Power switch
12
Drive enclosure 1
Controller enclosure
Drive enclosure
Drive enclosure
Controller enclosure
P3AM-4872-11EN