Loading Discs - Epson Disc Producer PP-100 User Manual

Loading Discs

This section describes how to load discs into the input stacker, and insert it.
Load the discs into a stacker. Do not load discs in the drives or printer. Furthermore, with
the PP-100, do not load discs between Drive 1 and Drive 2. They may become unable to
be removed.
1 Fully separate the discs to prevent them from sticking together.
 Be sufficiently careful not to scratch a disc.
 If a long time elapses after discs are loaded in the stacker, the separated discs may
stick together again. Fan the discs again if a long time has elapsed since they were
loaded.
2
Open the disc cover.
For precautions when you open the disc cover, see
3
Take out the input stacker and load the discs into it.
 Do not load discs above the red line on the stacker. The product may malfunction, or
the discs may be damaged.
 Make sure that the bottom of the stacker is not dirty before loading the discs.
The stacker to use as the input stacker differs depending on the product model and the set publish mode.
Confirm the input stacker in the following table.
For PP-100/PP-100AP
Publish Mode
Standard Mode
External Output Mode
(Different types of discs can be loaded into Stacker 1
and Stacker 2.)
Batch Mode
60
"Opening the Disc Cover" on page
Place the label surface facing upwards.
Input Stacker
Stacker 1 Up to approximately 50 discs
Stacker 1 Up to approximately 50 discs
Stacker 2 Up to approximately 50 discs
Stacker 1 Up to approximately 50 discs
Stacker 2 Up to approximately 50 discs
20.
Number of Discs