Fitting Cd3500 To Door - Siemens Codoor CD3500 Installation & User Manual

CD3500 & CD4000 Installation and User manual

Fitting CD3500 to door

1 1
3 3
4 4
1. Remove the cylinder ring
and the door handle from
the door by loosening the
four screws.
2. The lever handle spindle
should project no more
than 20 mm on the outside
of the door. If the spindle
is too long, push it through
into the handle on the
inside. If this cannot be
done, cut the spindle to
the right length.
3. Screw the
extension sleeves to the nipples for the handle.
Use the appropriate size sleeve to suite the bolts
supplied with the handles.
4. Place Codoor on the outside of the door with the
handle attached, and
pass the lever handle
spindle through the
square hole. Note! The
red mark on the follower
should always point
downwards.
5. Tighten, not too hard,
RED RED
supplied
the four
previously
5 5
loosened
screws (the
screws for the handle first).
9
2 2