GE Allegro User Manual page 29

Wireless System doesn't respond to commands entered from the wireless touchpad.
touchpad
Check the touchpad for dead batteries and replace batteries if needed.
If problem persists, contact your dealer/installer.
Touchpad reports a trouble condition.
Check the touchpad battery for low voltage. Replace the battery if necessary.
If problem persist, contact your dealer/installer.
Wireless System doesn't respond (in sensor test or when armed) when sensor is tripped.
sensor zone
Contact your dealer/installer.
or DTIM
Sensor or DTIM reports a trouble condition.
Perform a sensor test. If trouble condition persists, contact your dealer/installer.
Panel tamper The touchpad reports a panel or phone module tamper.
Verify that the panel or phone module (DTIM) cover is closed.
Trouble Panel sounds four short beeps every minute.
beeps
A trouble condition exists. Press Status. See Table 12 on page 30 to determine the
cause.
Allegro Control Panel User Manual 25