Registration Of Projector To "Projectorview Global - Mitsubishi Electric View Global+ User Manual

4. Projector registration

4.2. Registration of projector to "ProjectorView Global+"

The procedures to register projectors vary among the foregoing connection examples.
• In connection examples 1 and 2 (where projectors are installed within the same local network), the projectors within
such network are automatically detected and registered. For details, see procedure A below.
• In connection examples 3 (where projectors are installed via a router), specify the range of the projectors' IP
addresses and then carry out automatic projector search within the range to register projectors. For details, see
procedure B below.
• Up to 200 units of projectors can be registered at the maximum.
• Projectors that have just been registered by the automatic projector search aren't belonging to any group. When
the projectors you registered aren't displayed on the projector list on the main screen, select "All" from the group
select pull-down menu.
Procedure A - For connection examples 1 and 2 (where projectors are installed within the
same local network)
(1) Start up "ProjectorView Global+".
(2) Select "Search Projector" from "Configuration" of the menu bar on the main screen.
• The projectors connected to LAN are searched automatically.
• Some projectors may require you to enter the password when establishing projector connections for the first time.
If the projector password is changed, you need to enter that new password.
<Note>
• Note that a different IP address may be assigned every time you start the projectors. If a connection cannot be
established, execute "Search Projector".
• If you change the IP address in the projector menu after the projectors have been detected, execute "Search
Projector" again.
• When the projector is not found by carrying out "Search Projector", please manually set the projector's IP address
to IP address of the same network group as PC before carrying out "Search Projector".
• If several projectors with the same IP address are registered, delete the ones which are not connected to the
network from "Edit Projector Setting".
• Ensure that the IP address of the PC and that of the projector are in the same network group. (The last octet of the
IP address should contain a different value.)
• Be sure to make a note of the IP addresses you set. If you forget the IP addresses, you may not be able to detect
the projectors again.
• It is recommended that you assign an IP address of the projector to the fixed IP address.
EN-10