Mitsubishi Electric View Global+ User Manual page 11

Procedure B - Connection examples 3 (where projectors are installed via a router)
To automatically detect projectors connected via a router, specify a range of IP addresses to search that particular IP
address using "Search Projector Setting".
(1) Start up "ProjectorView Global+".
(2) Select "Search Projector Setting" from "Configuration" of the menu bar.
• "Search Projector Setting" window is displayed.
Item
Start IP Address
End IP Address
Search Projector
(3) Specify the projector search range by IP address (
• Up to 16 search ranges can be set. (Settings can be configured for each line of the search range.)
(4) To save the settings, click [Save]. To continue the projector search, click [Search Projector].
• When you click [Save], the search ranges you specify are saved and the "Search Projector Setting" window is
closed.
• When you don't want to save the search ranges, click [Cancel] to close the "Search Projector Setting" window.
• After saving the settings, by selecting "Configuration" on the menu bar and then selecting "Search Projector",
you can perform automatic projector search within the search ranges you saved.
• Some projectors may require you to enter the password when establishing projector connections for the first
time. Authentication is automatically performed from the second time onwards unless projectors are deleted
from the list.
Description
Specify the IP address that is the start of the search range.
(You cannot specify an IP address that contains a range other than 1 to 254 for the first
and last octets and a range other than 0 to 255 for the second and third octets.)
Specify the last octet of the IP address that is the end of the search range. (You cannot
specify a value that contains a number other than 1 to 254. In addition, you cannot
specify a value that is smaller than the last octet of the search start IP address specified
in step .)
The settings you made are saved and then the automatic projector search is performed.
and ).
EN-11