Advertisement
/pci@#,#/FJSV,(e)ulsa@#(fjulsa#):
scsi reset delay of 0 is not recommended, resetting to SCSI_DEFAULT_RESET_DELAY
Because 0 is specified for the scsi-reset-delay property, the default value is restored. Review the settings in the fjulsa.conf
file.
/pci@#,#/FJSV,(e)ulsa@#(fjulsa#):
transfer rate and width for Target (#,#) was set up.
transfer rate = %s, width = %ss
The transfer rate was changed.
%s="#ns" "async"
%ss="Wide" "Narrow"
Confirm whether the SCSI device supports the synchronous transfer mode and wide transfer mode if %s is "Async" and %ss
is "Narrow". When either mode is not supported, no problem occurred. When either mode is supported, contact customer
support.
/pci@#,#/FJSV,(e)ulsa@#(fjulsa#):
ulsa_hbaq_delete: target #- was on hbaq # times.
More than one logical unit is registered with hbaq. No problem occurred.
/pci@#,#/FJSV,(e)ulsa@#(fjulsa#):
function # done, IOCStatus = #, IOCLogInfo = #
Unexpected status was notified from SCSI control chip.
/pci@#,#/FJSV,(e)ulsa@# (fjulsa#):
target#-scsi-options=#
A value of the target#-scsi-options property was specified.
No problem occurred.
/pci@#,#/FJSV,(e)ulsa@# (fjulsa#):
loginfo = #
The loginfo information was reported from the SCSI control chip.
If a WARNING message has been output before this message, follow the instructions given in the WARNING message.
Advertisement
