Epson PP-100 User Manual page 22

❏ Try to test print on a spare CD/DVD, and check the printed surface after waiting for one
full day, especially before printing a large number of CDs/DVDs.
❏ After printing the first copy, check the print quality to see if any dots are missing.
❏ Before using or touching the printed surface of your CDs/DVDs, make sure they are
completely dry and keep them out of direct sunlight.
❏ If the printed surface is sticky even after it has dried, do the following.
1. Change label type.
2. Change color saturation level.
3. Change the disc.
❏ Moisture on the printable surface may cause smearing.
❏ When using Epson specified discs, High Speed can not be selected.
❏ Reprinting on the same CD/DVD may not improve the print quality.
❏ Be sure to clean the inside of the stacker before using if there are any dirt.
❏ Please check disc before printing, as the size of the receptor may vary.
❏ Ink may not bond if printed outside the receptor.
❏ If the product is operating, wait for 10 seconds after the operation is finished, and then
turn the power off.
❏ Data may be lost depending on the disc or storing condition; therefore, store important
data on multiple discs. Epson does not guarantee the data against loss.
❏ Do not insert a disc between DVD drive 1 and DVD drive 2, as you may not be able to
remove it.
❏ Do not insert an object like a screwdriver or clip into the CD/DVD slots as this may
cause a malfunction.
❏ A published CD/DVD may not be readable on another type of drive or player due to
compatibility.
❏ The quality of the blank disc determines print and write quality. It is recommended to
use only the specified disc type.
❏ It is recommended that you run a compare while writing data.
❏ Making a backup is recommended if the data is important. Recorded data may degrade
over long storing periods. It is recommended to make backups periodically.
22
Publishing Discs