When Web Control Administrator Rights Password Is Not Set (Non-Protect Mode) - Panasonic PT-DZ570E Network Manual

Control commands via LAN (continued)

When WEB Control administrator rights password is not set (Non-protect mode)

Connection method
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and
make a request for connection to the projector.
You can obtain both IP address and port number from the menu screen of the projector.
IP address : Obtain from MAIN MENU → [NETWORK] → [NETWORK STATUS]
Port No. : Obtain from MAIN MENU → [NETWORK] → [NETWORK CONTROL] → [COMMAND PORT]
2) There is a response from the projector.
Response data
Data section
"NTCONTROL"
(ASCII string)
9 bytes
Mode : 0 = Non-protect mode
Command transmission method
Transmit by the following command format.
Transmitted data
'0'
0x30
1 byte
Receive data
'0'
0x30
1 byte
Receive data
"ERR1"
"ERR2"
"ERR3"
"ERR4"
"ERR5"
"ERRA"
Header
'0'
0x30
1 byte
Header
'0'
0x30
1 byte
Error message
Undefined control command
Out of parameter range
Busy state or no-acceptable period
Timeout or no-acceptable period
Wrong data length
Password mismatch
4 bytes
Blank Mode
' '
0x20 0x30
1 byte 1 byte
Data section
Control command
(ASCII string)
Undefined length
Data section
Control command
(ASCII string)
Undefined length
39
Termination symbol
'0'
1 byte
Termination symbol
1 byte
Termination symbol
1 byte
Termination symbol
1 byte
(CR)
0x0d
(CR)
0x0d
(CR)
0x0d
(CR)
0x0d