Setup Files; Changing File Settings; Saving File Settings - Sony DXC-D35 Service Manual

Setup Files

To call up files recorded onto a tape (when
using the DSR-1/1P)
First, connect the DSR-1/1P to the camera head and
load the cassette that contains the recorded files.
1
Set the SET UP switch to FILE.
2
Access advanced menu page 10.
3
Move the cursor to SELECT FILE and use the UP/
ON button or the DOWN/OFF button to select
TAPE.
4
Move the cursor to CHG FILE and press the UP/
ON button.
The screen appears as shown below.
72
Chapter 4 Viewfinder Screen Indications and Menus
5
Press the UP/ON button to call up the file. To
abort the call up operation, press the DOWN/OFF
button (the display returns to the one shown in step
3).
During the call up operation, the following display
appears.
When the call up operation ends, the display
changes as shown below.
Name of file
recorded onto
tape
The settings of the camera head are now replaced
by the settings in the called file.

Changing File Settings

When using advanced menu page 11 or 12, you can
change the settings about picture quality in setup files.
(In basic menu page 1, a part of items are changeable.)
The changes are accepted only until another file is
called up, after which the original settings are restored.
If you save the changes, store the modified file as one
of the user files or record it in a cassette. (See the
following section "Saving File Settings".)
1
Perform the steps described in "To call up files
recorded onto a tape (when using the DSR-1/1P)"
above to call up the selected file.
2
Access advanced menu page 11 or 12.
Currently selected
file a)
Currently selected
file a)
a) An asterisk (*) appears in front of any factory preset
file whose contents have been revised at least once.
3
Make the desired changes.
Page 11
Item Settings
M.BLACK, STRETCH and See "Basic menu page 1"
DTL LEV (page 58).
M.GAMMA –99 to ±0 (normal value) to
Adjusts the gamma curve.
+99
V DTL LEV –99 to ±0 (normal value) to
Adjusts the vertical detail. +99
DTL FREQ LL, L, M (normal value), H,
Adjusts the central HH
frequency of the detail.
Page 12
Item Settings
SAT –99 to ±0 (normal value) to
Adjusts the saturation of the +99
image. Negative adjustment values
decrease the saturation and
positive adjustment values
increase the saturation.
HUE –99 to ±0 (normal value) to
Adjusts the hue of the +99
image.
SKIN SAT –99 to ±0 (normal value) to
Adjusts the saturation in the +99
specified area of the image. Negative adjustment values
decrease the saturation and
positive adjustment values
increase the saturation.
SKIN HUE –99 to ±0 (normal value) to
Adjusts the hue in the +99
specified area of the image.

Saving File Settings

Files whose settings have been changed for certain
shooting conditions can be saved as a user file or onto
a tape (when using the DSR-1/1P).
For details, see "To save setup files to a tape (when using
the DSR-1/1P)" (page 74).
1
Set the SET UP switch to FILE.
SET UP switch
2
Call up a setup file whose settings approximate the
desired shooting conditions and then change some
of the settings.
For details of this operation, see "Calling up a Setup
File" (page 71), "Changing File Settings" (in the left
column on this page), "Basic Menu Operations" (page
58), and "Advanced Menu Operations" (page 64).
(continued)
73
Chapter 4 Viewfinder Screen Indications and Menus