Throttle Position Sensor (Tps) - Yamaha Fazer Service Manual

Â
À
¿
À
¿
CARBURETOR TUNING
• Otherwise adjust Float level by bending the
Float Tang  on the Float slightly up or down
as required.
• Install the Carburetor
• Recheck the fuel level
• Adjust Float height through Float Tang Â
By Bending Down Ÿ Float Height increase
By Lifting Up
CHECKING AND ADJUSTING THE
THROTTLE POSITION SENSOR
• Check/adjust the idle rpm - 1300~1500
• Remove the TPS Coupler from TPS
Unit mounted at carbruettor.
• Check TPS resistance at idling throttle
position without starting the engine.
• Make connection as below
Multimeter
+
-
Specification
At Idling
• Check TPS resistance at full throttle
position without starting engine
Multimeter
+
-
Specification
By slowly
opening
the throttle
If out of specifi cations, replace YTPS
5-10
CARB
Ÿ Float Height Decrease
YTPS
Terminal of Blue wire ¿
Terminal of Black wire À
3.5 ~ 6.5 K Ohms
YTPS
Terminal of Yellow wire ¿
Terminal of Black wire À
0 ~ 5 K Ohms