Installation; Preparing To Install - Bosch PHW206FAU User Instruction & Installation Manual

Installation

Statutory
requirements
Preparing to
install
Natural gas
Pressure
test point
520
1
This installation must conform with the following:
• Manufacturer's Installation instructions
• Local Gas Fitting Regulations
• Municipal Building Codes,
• AGA Installation Code for Gas Burning Appliances.
(AS 5601 - 2004 - Gas Installations).
• S.A.A. Wiring Code
• Local Electrical Regulations
• Any other statutory regulations
Refer to the AGA Installation Code for piping size details.
These built-in hobs are intended to be inserted in a
benchtop cutout.
Only an officially authorised technician should connect
the appliance.
Before you begin, turn off the gas and electricity supply.
Installation dimensions are shown in Fig.1-1a.
Universal LPG
30
30
30
Pressure
test point
590
43
Gas inlet
connection
min 30 / max 60
Before connecting the unit, check whether the local
connection conditions (type of gas) are compatible with
the unit's setting. Observe any special conditions imposed
by local suppliers (utilities). The specifications of this
cooktop are stated on the data label located on the
bottom of the cooktop base.
A duplicate data label is supplied for adhesion to
an accessible location near the hotplate if the data
label on the base of the hotplate cannot be
accessed when the hotplate is installed.
Natural gas
30
Pressure
test point
512
43
1a
Universal LPG
95
Pressure
test point
702
min 30 / max 60
30
Gas inlet
connection
6