Installation
Preparing the Cabinet for Installation
B
1. Remove the lower housing cover (A) by pulling
outward on the handle.
2. Remove two phillips screws from the transformer
access cover (B). Pull the cover outward from the bot-
tom to remove.
3. Three lower mounting holes are provided. The center
hole is open and the outer holes are plugged. If you
intend to use the outer holes for installation, carefully
22
drill through the plugs with a 3/16" (5mm) drill bit.
O N
M A N
U A L
ST A
R T
N E X
T
O FF
R
R
R R
A
BATTERY
D
E
Three wiring access holes are provided in the cabinet
base as follows:
(D) - 1/2" (13mm) for power and equipment ground wires.
(E) - 1/2" (13mm) (plugged) for optional Toro Rain Switch
wires.
(F) - 3/4" (19mm) for sprinkler valve wires.
4. If planning to install the optional Toro Rain Switch,
remove the plug (E) by carefully tapping it out with a
screwdriver or punch.
®
ON
MANUAL
NEXT
START
PROGRAMS
A
B C
OFF
C
F