Connecting The Power Source - Toro ECx User Manual

Connecting the Power Source

AC power wiring must be installed and connected
by qualified personnel only. All electrical compo-
nents and installation procedures must comply
with all applicable local and national electrical
codes. Some codes may require a means of discon-
nection from the AC power source installed in the
fixed wiring and having a contact separation of at
least 0.120" (3mm) in the line and neutral poles.
Make sure the power source is OFF prior to con-
necting the controller.
1. Route the power and equipment ground wires from the
power source, through the conduit and into the con-
troller transformer compartment.
Note: The controller terminal block accepts wire size
up to 12 AWG (4mm
2. Remove 3/8" (10mm) insulation from the wire ends.
3. Using a small flat blade screwdriver, secure the wires
as shown to the terminal block positions as follows:
Line to L, Neutral to N and Equipment Ground to
Note: The bottom terminal is not used.
4. Install and secure the transformer compartment
cover.
5. Apply power to the controller.
26
WARNING:
2 ).
.
BATTERY