Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Huawei EchoLife HG520b
Summary of Contents for Huawei EchoLife HG520b
-
Page 1: User Manual
EchoLife HG520b Home Gateway User Manual HUAWEI TECHNOLOGIES CO., LTD. - Page 2 Copyright © Huawei Technologies Co., Ltd. 2008. All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means without prior written consent of Huawei Technologies Co., Ltd. Trademarks and Permissions and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd.
-
Page 3: Fcc Radiation Exposure Statement
Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. -
Page 4: Safety Precautions
Safety Precautions For safety purposes, carefully read through these safety precautions and observe them during operation. Basic requirements Keep the device dry during storage, transportation, and operation of the device. Prevent collision of the device with other objects during storage, transportation, and operation of the device. - Page 5 Use the accessories such as the power adaptor provided or authorized only by the manufacturer. Make sure that the device does not get wet. If water gets into the device, disconnect the power supply immediately and unplug all the cables connected to the device, such as the power cable, and then contact the authorized maintenance center.
- Page 6 Do not clean the device cover with any cleaning solution or cleanser spray. Use a piece of soft cloth to clean the device cover. Wireless Product Usage Requirements Keep the device away from magnetic storage devices (e.g., a magnetic card or a floppy disk), to prevent loss of the stored information.
-
Page 7: Table Of Contents
1.1 Functions and Features............1 1.2 Hardware Configuration ............1 1.2.1 Front Panel ..............2 1.2.2 Rear Panel..............3 1.2.3 Splitter.................4 Chapter 2 Installation of the HG520b ..........5 2.1 Preparation................5 2.2 Connecting the HG520b............5 2.3 Establishing Configuration Environment .......6 2.3.1 Parameter Configuration..........6 2.3.2 Steps................6 2.4 Web Configuration Page ............7... - Page 8 3.7 Configuring the Wireless Mode ...........15 3.7.1 Preparation ...............15 3.7.2 Steps.................15 Chapter 4 Other Settings ..............17 4.1 Changing the IP Address of the LAN of the HG520b..17 4.2 Changing the Administrator Password........17 4.3 Restoring the Default Factory Settings .......18 Chapter 5 Troubleshooting ...............20 5.1 Quick Failure Location............20...
-
Page 9: Chapter 1 Introduction
HG520b Home Gateway (hereinafter referred to as the HG520b). 1.1 Functions and Features The HG520b is a type of Asymmetric Digital Subscriber Line (ADSL) terminal. Data, video and audio are transmitted through the common telephone line at a higher rate by the HG520b. -
Page 10: Front Panel
Note: Figures of the front panel and the rear panel are only for your reference. 1.2.1 Front Panel Figure 1-1 shows the front panel of the HG520b. POWER WLAN LAN1 LAN2 LAN3 LAN4 INTERNET ADSL Figure 1-1 Front panel of the HG520b Table 1-1 shows indicators in the front panel. -
Page 11: Rear Panel
There are data being transmitted in the INTERNET Blinking INTERNET interface. The HG520b is in the bridge mode or the PPPoE/PPPoA connection is not established. 1.2.2 Rear Panel Figure 1-2 shows the rear panel of the HG520b. -
Page 12: Splitter
To connect the telephone jack or a splitter through a telephone line. At the side of HG520b. To restore the default settings of the HG520b, press the RESET RESET button and release it after six seconds. Once you use this function, all your custom settings will be lost. Therefore, please be careful when using it. -
Page 13: Chapter 2 Installation Of The Hg520B
Chapter 2 Installation of the HG520b This chapter introduces the installation when the HG520b is used for the first time. 2.1 Preparation Connect your computer with the HG520b through the Ethernet interfaces. Before installing the HG520b, make sure that your computer is equipped with the network card 2.2 Connecting the HG520b... -
Page 14: Establishing Configuration Environment
2.3 Establishing Configuration Environment You can configure the HG520b on the Web configuration page. This section describes the process to establish the configuration environment of the HG520b. 2.3.1 Parameter Configuration Before establishing the configuration environment, set the following parameters. Table 2-1 Parameters for the configuration environment... -
Page 15: Web Configuration Page
Chapter 3 "Service Configuration." 2.4 Web Configuration Page The Web configuration page of the HG520b is divided into two parts: The navigation tree: It is on the left side of the page. It provides you to access to different configuration pages. -
Page 16: Chapter 3 Service Configuration
The HG520b supports multiple service modes and the configuration of the DSLAM at the office end should be considered when you select a service mode. Table 3-1 lists the service modes of the HG520b. Table 3-1 Service modes of the HG520b... - Page 17 IPoA = Internet Protocol over ATM PPPoE = PPP over Ethernet PPPoA = PPP over ATM Caution: Some parameters are validated only after they are saved and the HG520b is rebooted. Follow the prompt in the configuration page to perform this operation.
-
Page 18: Configuring The Bridge Mode
3.2 Configuring the Bridge Mode In the bridge mode, the HG520b serves as a bridge. You need to install the Point to Point Protocol (PPP) dial-up software to realize the dial-up access to the Internet. This section describes the process to configure the HG520b to work in the bridge mode and the process to configure your computer to access the Internet through the HG520b. - Page 19 1. Configuring the HG520b Follow the steps: Log in to the Web configuration page of the HG520b. For the procedure, refer to "2.3 Establishing Configuration Environment." Select Basic > WAN Setting in the navigation tree to display the WAN configuration page.
-
Page 20: Configuring The Pppoa Mode
3.3 Configuring the PPPoA Mode In the PPPoA mode, the HG520b uses the embedded PPP dial-up software for dialing. The HG520b serves as a router to connect your computer to the Internet. This section describes the process to configure the HG520b to work in the PPPoA mode and the process to configure your computer to access the Internet through the HG520b. -
Page 21: Configuring The Ipoa Mode
IP address and the gateway. 3.4 Configuring the IPoA Mode This section describes the process to configure the HG520b in the IPoA mode and the process to configure your computer to access the Internet through the HG520b. -
Page 22: Steps
IPoA. For details, refer to 3.4 "Configuring the IPoA Mode." 3.6 Configuring the PPPoE mode In the PPPoE mode, the HG520b uses the embedded PPP dial-up software for dialing. Configuring the PPPoE mode is similar to configuring the PPPoE mode. -
Page 23: Configuring The Wireless Mode
In the Wireless mode, the HG520b makes you access the Internet without connecting a cable. This section describes the process to configure the HG520b to work in the Wireless mode and the process to configure your computer to access the Internet through the HG520b. - Page 24 Select Basic > Wireless LAN in the navigation tree to display the Wireless configuration page. In the Wireless configuration page, enable wireless and configure the relevant parameters according to the values in Table 3-5. Select one of the Authentication Type. And configure the relevant parameters.
-
Page 25: Chapter 4 Other Settings
HG520b You can access the Web configuration page of the HG520b through the IP address of the LAN of the HG520b. The IP address of the LAN of the HG520b is configured by default, you can change it as follows: Log in to the Web configuration page of the HG520b. -
Page 26: Restoring The Default Factory Settings
You can change the administrator password, follow the steps: Log in to the Web configuration page of the HG520b. For the procedure, refer to "2.3 Establishing Configuration Environment." Select Tools > System Management in the navigation tree to display the Account configuration page. - Page 27 2. Using the Web Manager Follow the steps: Select Tools > Reboot in the navigation tree. Click Factory Default Settings and click Restart to restore the default factory settings.
-
Page 28: Chapter 5 Troubleshooting
Solution Ensure that the power adapter matches the HG520b. The Power Ensure that the HG520b is connected to the power indicator is not on supply properly. Ensure that the ON/OFF button is pressed. Ensure that only the network cable provided with the HG520b is used. -
Page 29: Faqs
ISP's access server, line disconnection and line disturbance. You can check as follows: Make sure that the ADSL line is connected properly. Keep the HG520b away from appliances with strong electric fields or magnetic fields, such as a microwave oven or a refrigerator. - Page 30 If the username and the password of the Web configuration page are forgotten, configure the HG520b to the default factory settings. Use the default username and password to access the Web manager. For restoring the default factory settings, refer to 4.3 "Restoring the Default Factory Settings."...
-
Page 31: Chapter 6 Technical Specifications
Chapter 6 Technical Specifications Physical Features and Environmental Requirements Power consumption Less than 7 W Power supply 12 V DC, 1.0 A Ambient temperature °C °C –40 in operation Ambient humidity in 5%–95%, non-condensing operation Dimensions 188 mm × 140 mm × 30 mm Weight About 320 g... -
Page 32: Chapter 7 Appendix
Chapter 7 Appendix 7.1 Default Factory Settings Item Default Value Username of administrator admin Password of administrator admin IP address 192.168.1.1 Subnet mask 255.255.255.0 7.2 Abbreviations ADSL Asymmetric Digital Subscriber Line Asynchronous Transfer Mode DHCP Dynamic Host Configuration Protocol DSLAM Digital Subscriber Line Access Multiplex Internet Protocol IPoA... - Page 33 HUAWEI TECHNOLOGIES CO., LTD Huawei Industrial Base Bantian, Longgang Shenzhen 518129 People's Republic of China www.huawei.com Part Number: 202072...