Digital Audio Output - Haier 42EP25SAT Owner's Manual

External Equipment Connections
DTV connection
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV`s (Y, P , P ) , VGA or HDMI
B R
jack for video connections, depending on
your set-top box connector. Then, make
the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the owner`s
manual for the digital set-top box.)
2. Use INPUT on the remote control to select
YPbPr, VGA,or HDMI source.
Signal YPbPr
480i Yes
480p Yes
720p Yes
1080i Yes

Digital Audio Output

Send the TV`s audio to external audio equipment (stereo system) via
the Digital Audio Output (Optical) port.
How to connect
1. Connect one end of an optical cable to the TV Digital Audio
(Optical) Output port.
2. Connect the other end of the optical cable to the digital audio (optical)
input on the audio equipment.
See the external audio equipment instruction manual for operation.
Note: When connecting with external audio equipments, such as
amplifers or speakers, please turn the TV speakers off.
Caution: Do not look into the optical output port.
Looking at the laser beam may damage
your vision.
HDMI/DVI
Yes
Yes
Yes
Yes
Y Pr Pb
DVI Audio IN
PC Audio In
Digital Set-top Box
HDMI
Installation
L R
YPbPr Headphone
HDMI
Optical
Audio In out
L R
YPbPr Headphone
Optical
out
Audio In
Owner s Manual 15