GE JGP633 Installation Instructions Manual page 14

Installation Instructions
MAKING THE LP CONVERSION (CONT.)
B]
CHANGE COOKTOP BURNER
ORIFICES
Remove the top grates,
burner caps, and burner
heads.
Remove the spark
igniters from the burner
base (if required to
access the orifices).
Using a No. 15 "Torx"
head driver bit, remove
the screws holding the
burner base in position.
Remove This
,!Assembly
Orifice Spud Located
Through This Opening
Using a 7mm nut driver,
remove the top burner
orifices. These may be
accessed through the
hole in the cooktop.
Burner cap
Burner
Spark igniter base
18,000 BTU Burner
(on some models)
_Burner
Burner head
base
Spark igniter
r_ CHANGE COOKTOP BURNER
ORIFICES (CONT.)
NOTE: On most burners,
the orifices have a spring-
loaded retaining ring around
the hex head to hold the
orifice in the nut driver during
installation and removal. A
_ etainer
Ring
slight amount of force is required to push the nut
driver down over the ring.
14