GE JGP633 Installation Instructions Manual page 9

Installation Instructions
USAGE SITUATIONS WHERE
APPLIANCE POWER CORD
WILL BE DISCONNECTED
INFREOUENTLY
For 15 amp circuit only. Do not use Gn adaptor
on a 20 Gmp circuit. Where local codes permit, a
TEMPORARY CONNECTION may be made to G properly
grounded two-prong wGII receptacle by the use of a
UL-listed adaptor available at most hardware stores.
The larger slot in the adaptor must be Gligned with
the large slot in the wall receptacle to provide proper
polarity in the connection of the power cord.
Ensure proper ground and firm
II connection before use
Align Iorge
prongs/slots
Temporory Method
(Adoptor plugs not permitted in Conodo)
A CAUTION:
Attaching the adaptor ground
terminal to the wall receptacle cover screw does not
ground the GppliGnce unless the screw is metal, and
not insulated, Gnd the wall receptacle is grounded
through the house wiring. The customer should have
the circuit checked by a qualified electrician to make
sure the receptacle is properly grounded.
When disconnecting the power cord from the
adaptor, always hold the adaptor with one hand. If
this is not done, the adaptor ground terminal is very
likely to break with repeated use. Should this happen,
DO NOT USE the appliance until a proper ground has
again been established.
Usage situation where appliance power cord will be
disconnected frequently.
Do not use an adaptor plug in these situations
because disconnection of the power cord places
undue strain on the adaptor and leads to eventual
failure of the adaptor ground terminal. The customer
should have the 2-prong receptacle replaced with
a 3-prong (grounding) receptacle by a qualified
electrician before using the appliance.