Page 1
Installation Instructions Full Size Tumble Action Washers Before beginning installation, carefully read these instructions• This will simplify installation and ensure the washer is installed correctly and safely• Leave these instructions near the washer after installation for future reference• NOTE: The electrical service to the washer must conform with local codes and ordinances and the latest edition of the National...
Page 2
PRE-INSTALLATION REQUIREMENTS into an appropriate, copper wired receptacle that is properly installed and grounded in accordance with all local codes and ordinances or in the absence of local Tools Required for Installation: 1/4 in. nut driver codes, with the National Electrical Codes, ANSI/N FPA 3/8 in.
Page 3
ROUGH-IN DIMENSIONS 17 1/2 263/4 (152.4) "_ (67.9) 21/2 27/8 (61) (7.3) 113/4 .- (6.4) (29.8) 11/2 351/4 (89.5) Water Inlets Power Cord (80.3) 331/2 (85) BACK SIDE Adjustable Legs inch (cm) 171/2 263,4 (44.5)_ (152.4)_J (67.9) 21/2 (61) (6.4) =(2.54) 113/4 J (7.3)
Page 4
LOCATION OF YOUR WASHER DO NOT INSTALLYOUR WASHER: In an area exposed to dripping water or outside Remove the styrofoam base. weather conditions. The ambient temperature Carefully return the washer to an upright position and remove the carton. should never be below 60 ° F (15.6 ° C) for proper washer (detergent breakdown) operation.
Page 5
Rear leg adjustment is accessible through the front service panel. Turn the lock nuts on each leg up towards the www.frigidaire.com, for the Frigidaire Company base of the washer and snug with a wrench. Authorized Parts Distributor nearest you.