Craftsman 142.18894 Operation Manual page 19

Tool-free Depth Adjustment
(See Figure 8)
Selectable Trigger
Rear Exhaust with Muffler
Male Coupling
Dust Cap
LED Light
Quick Jam
Reversible Belt Hook
With Hex Wrench storage
Tool Noseplate
Magazine Cover
Magazine Cover Release Latch
No-Mar Tip Storage
(Reverse Side of Tool)
FEATURES BENEFITS
Oil-less Design Requires no regular maintenance
and eliminates the risk of oil stains
1. Tool free design for user friendly
Tool-free Depth Adjustment 2. Control for precise countersinking
LED Light Offers clearer view in darker areas
Tool free mechanism to open the
Quick Jam Clearance
nose piece to clean the jam
Prevents making mark on the
No-Mar Contact Trip Pad
workpiece
Reversible Belt Hook with
Provides convenient tool carrying
Wrench storage
Trigger has two operation settings:
Selectable Trigger 1. Single trigger pull firing
2. Continuous contact trip firing
1. Ultra-quiet
Rear Exhaust with Muffler 2. Directs air away from the user
during operation
SPECIFICATIONS
Capacity ........................................ 100 Nails or Staples
Nail Size ....................................................... 18 Gauge
Nail Lengths ................................................... 5/8" to 2"
Staple Size ................................ 1/4" Crown, 18 Gauge
Staple Length ......................................... 1/2" to 1-9/16"
Operating Pressure .................................... 70-120 PSI
Air inlet ......................................................... 1/4" N.P.T.
Tool Length ........................................................... 10.1"
Tool Height ............................................................ 11.2"
ToolWidth ............................................................... 2.5"
Tool Weight ...................................................... 2.88 Ibs
LED LIGHT
• Requires CR2023 battery (supplied)
• 15 minute automatic shut-off to conserve battery
power in case light is not turned off after tool use.
CHANGING THE BATTERY (See Figure 1 & 2)
• Open the tool noseplate.
• Remove the soft protection pad by pulling up on
one of the side tabs. (See Figure 1).
• Use small screwdriver or other blunt instrument
to push battery up and out of receptacle. (See
Figure 2).
• Insert new battery into receptacle. Positive side
will face out.
• Replace the soft protection pad.
• Close tool noseplate.
Figure 1 Figure 2