Level Washer; Installing Coin Slide And Coin Box - Kenmore 27122310, 2992310 Installation Instructions Manual

LEVEL WASHER
iMPORTANT: Level washer properly to reduce excess noise
and vibration.
Excessive Weight Hazard
Use two or more people to move and install washer/dryer.
Failure to do so can result in back or other injury.
1. Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check levelness
of sides. Check levelness of front using lid, as shown. Rock
washer back and forth to make sure all four feet make solid
contact with floor.
HELPFUL TiP: You may want to prop up front of washer about
4" (102 ram) with a wood block or similar object that will support
weight of washer.
Models with
plastic feet
Place level here
Place level here
or
Models with
metal feet
Jam nut
3. On models with metal feet, when washer is level, use a
9/16" or 14 mm open=end or adjustable wrench to turn jam
nuts counterclockwise on leveling feet tightly against washer
cabinet.
Not Level LEVEL Not Level
2. On models with metal feet, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer.
On models with plastic feet, use adjustable pliers to turn the
plastic leveling foot counterclockwise to lower the washer or
clockwise to raise the washer. On all models, recheck levelness
of washer and repeat as needed.
Jam nut
INSTALLING COIN SLIDE AND COIN BOX
The coin slide mechanism, service door lock and key, and coin box
loci< and key are not included with some models, but can
be obtained from the usual industry sources.
Remove the service door of the meter case by lifting it up at the
back. Install the money-accepting device. (Refer to manufacturer's
instructions for proper installation.)
For washer using coin slides, use the adapter kit supplied with the
washer.
Install a lock and cam on the meter case service door. Install the
coin vault with lock and key in the meter case opening.
12