Preparation; Installation; Frost Protection / Transport - Bosch WTC84101BY Installation And Operating Instructions Manual

Table of Contents

Advertisement

towels
hand
towels/
Tea
towels
Terry
linen
Table
linen
Bed
Socks
Underwear
robe
bath
towelling/
Terry
Anoraks
clothing
Work
Sportswear
Skirts/dresses
Trousers
Shirts
T-shirt

Installation

– Delivery includes: dryer, installation and instruction manual.
– Check dryer for transport damage.
– The dryer is very heavy. Do not lift without assistance.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
– Do not install in a room which is susceptible to frost. Water may cause damage once it
starts to freeze.
– If in doubt, have the appliance connected by a specialist.
Setting up the dryer
1.
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean,
level and firm surface.
– Do not obstruct the air inlet on the front of the
dryer.
– Keep the area around the dryer clean.
– Level the dryer using the front threaded feet.
On no account remove the threaded feet.
Do not install the dryer behind a door or a sliding
door which could obstruct the door of the dryer or
prevent it from being opened. Children can then
not be trapped inside and their life endangered.
Mains connection
For safety instructions,
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage must be the same as the voltage specified on the rating plate
(
see page 9).
– The connected load and necessary fuse protection are specified on the rating plate.
Changing the power input
3.
Press and hold the
Set to O (Off)
heat button and turn the
programme selector once
to the right.

Frost protection / Transport

Preparation

Empty the container for condensation
There may be residual water in the dryer.
This can leak out if the dryer is at an angle.
7
Remove all accessories from
the drum. The drum must be
empty.
Make sure that the air inlet
remains unobstructed
see page 11.
Ensure that the socket is fused.
10 A
16 A
or
Low
To change the
power input, press
the
(Easy-iron)
button.
Do not operate the dryer if there
is a danger of frost.
see page 4.
Clean and level
Set to O (Off)
8

Advertisement

Table of Contents
loading

Table of Contents