Table of Contents
Advertisement
Installation
Instructions
iSTEP 2 i REVERSE DOOR SWING
SKIPTHIS STEPIF DOOR SWING SUITSTHE
INSTALLATION
Parts Included:
• Top left case hinge
• Bottom left case hinge
• Left and right side decorative hinge cover
Decorative hinge screw hole cover
Torx®driver bit
Tools Required:
• Phillips screwdriver
• Electric drill
Remove the door:
• Flatten the shipping carton to use as a pad.
• Remove the 2 screws and the toekick. Set aside
the screws and toekick for final installation.
• Use the supplied Torx®bit and electric drill to remove
the 3 screws holding the top case hinge. Lift offthe
hinge. (Screws will be used to install the new hinge.)
• Lift the door off the bottom case hinge.
• Remove the bottom case hinge pin and bracket.
Rotate the door:
The handle will be on the right side of the door; hinges
will be installed on the left side of the case.
• Remove the door stop and cam riser on the original
bottom right side of the door.
• Remove the fill plug on the top right side
of the door.
• Turn the door over and reinstall the fill plug on
the new left side.
Reinstall the door:
• Install the original door stop and cam riser onto
the bottom left side of the door.
• Install the new supplied bottom case hinge pin and
bracket onto bottom left side.
• Place the door onto the bottom case hinge.
• Install the supplied left-hand top case hinge with
the 5 original screws.
• Select the hinge cover marked with an "L".
• Peel backing off the tape inside the decorative hinge
cover.
Install C overs
• Press and snap the hinge
_
X_
ii
Ii1
• Snap the screw hole cover into
place on the opposite side.
i
IMPORTANT:
Check to be sure screws are tight and that the door
is straight and does not sag. The door should swing
freely.
Install
3 Hinge_
W
Screws!
I
Remove
Top Hinge
Remove
Hinge
Hinge
Pinand
Bracket
Apply Monogram Nameplate:
• Install the Monogram nameplate. See instructions
and template on back cover.
Install Toekick
The toekick has a
cutout on the left
and right sides.
Remove
the plug
on the left
side and
reinstall
on the right
'\,
side. If you
choose to
install the
stainless steel toekick,
reinstall the plug on the right side of that toekick.
• Install original screws and spacers or screws and
spacers supplied with the stainless steel toekick.
Install screws through the spacer standoff, toekick
and into the base as shown.
MoveFill
Advertisement
Table of Contents
